Advidia "A" Series Instrukcja Użytkownika Pobierz pdf (Strona 31)

Firmware User Manual

“Allowed” mode will refuse access to all IP addresses except the ones listed below.

“Blocked” mode will accept all incoming access except the IP addresses listed below.

Using Netmask (Subnet Mask) allows you to set filtering for a whole range of IP address at once, without

the need to enter all of them individually. If you are not sure about the function of Netmask, then you

should use 255.255.255.255, and it will affect only a single IP address per line of entry, or use

255.255.255.0 to use the same setting for all IP addresses starting with the same three numbers. .

After changing any of the items above, press Apply to save the changes. The Reset button undoes the

changes that had just been made but not applied yet.

Warning! Do not accidentally block your own IP address that you are connecting from; otherwise you will

not be able to access the camera any more to undo the changes. If this happens by mistake, you can do

the hardware reset – it will clear all the filtering rules.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 111 112

Brak uwag

Advidia "A" Series Instrukcja Użytkownika Strona 31